Die Cut Non-Iridescent Rod Decals
To Apply the Decal:
Lift the carrier sheet from the backing. The decal will peel up with the top sheet.
Place the decal down on the rod in the desired position.
Start from the middle and rub the bubbles from there to the edge. You may rub firmly or take a finishing tool and rub over the carrier sheet.
Peel the carrier sheet away and the decal remains in place. Your fingers never need to touch the decal because you have the carrier sheet to hold on to it.
Once applied, you are ready to apply your finishing coat of epoxy over the decal.
If you need exact measurement of these decals you can check Bill Mahr decals at decal connection
To Apply the Decal:
Lift the carrier sheet from the backing. The decal will peel up with the top sheet.
Place the decal down on the rod in the desired position.
Start from the middle and rub the bubbles from there to the edge. You may rub firmly or take a finishing tool and rub over the carrier sheet.
Peel the carrier sheet away and the decal remains in place. Your fingers never need to touch the decal because you have the carrier sheet to hold on to it.
Once applied, you are ready to apply your finishing coat of epoxy over the decal.
If you need exact measurement of these decals you can check Bill Mahr decals at decal connection
To Apply the Decal:
Lift the carrier sheet from the backing. The decal will peel up with the top sheet.
Place the decal down on the rod in the desired position.
Start from the middle and rub the bubbles from there to the edge. You may rub firmly or take a finishing tool and rub over the carrier sheet.
Peel the carrier sheet away and the decal remains in place. Your fingers never need to touch the decal because you have the carrier sheet to hold on to it.
Once applied, you are ready to apply your finishing coat of epoxy over the decal.
If you need exact measurement of these decals you can check Bill Mahr decals at decal connection
